Ruckus Wireless MF7211-Outdoor User's Guide download pdf (Page 58)

Ruckus Wireless ZoneFlex 2925/2942 User Guide | Managing the Access Point

Renewing or Releasing DHCP

This task should be performed only with guidance from your ISP. It serves as a troubleshoot-

ing technique when DHCP addresses to one or more networked devices prove to be unusable

or in conflict with others.

1 After logging in to the Web User interface, click Internet under Status.

2 Review the current settings.

3 If the current Connection Type is DHCP, you will be able to see the currently-assigned

IP address and subnet mask listed below.

• To force the DHCP server to assign a new IP address to this AP, click Renew DHCP.

This will cause a slight interruption in network service until the new IP address has

been put in use.

• To force the DHCP server to assign new IP addresses to all networked devices at the

same time (including this AP), click Release DHCP. This will cause a temporary

interruption in overall network service.

Upgrading the AP Firmware

You can use the Web User interface to check for software updates/upgrades for the firm-

ware built into the AP. You can then apply these updates to the device in one of two ways:

[1] manual updating on an as-needed basis or [2] automating a regularly scheduled update.

Before starting, decide which option you want to take:

• Automate a regularly scheduled update

• Run a one-time manual update right now.

By default, the automatic upgrade option is active, and will check the Ruckus Wireless

update server every 12 hours.

1 After logging into the Web User interface, click Upgrade under Maintenance.

FIGURE 4-16

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 66 67

No comments

Ruckus Wireless MF7211-Outdoor User's Guide Page 58