Ruckus Wireless ZoneFlex 2925/2942 User Guide | Installation, Setup, and Placement of the AP
8
FIGURE 2-4: Rear view
[1] Power Adapter Plug
Connect the power adapter to
this socket. (Input 110-240V AC, Output
12V 1.0A DC)
Power can also be supplied via 10/100
POE port.
[2] Lock Hasp
The lock hasp works with a cable or
Ruckus mounts. The recommended
lock type is Masterlock 120 series (D, T,
Q, KAD types).
[3] External RP-SMA Connector
Optional external antenna connector.
[4] LAN Ports
Two RJ-45 ports, supporting 10/100
POE (Power over Ethernet) and 10/100
Mbps connections.
[5] OPTIONAL Button
Not active in this model at this time.
[6] SOFT RESET Button
[-IF NEEDED-] Use to reset AP. This is
a normal reset and does not set AP
back to factory defaults.
Table 1: ZF2942 Side and Rear LEDs
LED If you see this... This is happening...
Power
• If this LED is steady green
• If off
• Power is ON.
• No power is connected.
OPT N/A Optional feature. Not active in this model at this time.
DIR
• If this LED is steady green
• If this LED is steady green for 2-3
seconds
• If flashing green
• If off
• Communication between Director and AP is up.
• The AP is booting up.
• Communication between Director and AP is down.
• AP is not under Director control.
1
3
4
5
2
6
Comments to this Manuals