Ruckus Wireless MF7211-Outdoor User's Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 67
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
Ruckus Wireless ZoneFlex 2925/2942 User Guide | Installation, Setup, and Placement of the AP
6
The following illustration shows the rear view of the ZF2925 AP and its major features.
LED If you see this... This is happening...
If this LED is dark
If green
No power is available, or the AP is not connected to a power source.
Power is available.
If this LED is dark
If steady yellow
If flashing yellow
If steady green
If flashing green
No link activity is detected
A 10Mbps-capable device has been detected.
Data is being exchanged through the WAN port at 10Mbps.
A 100Mbps-capable device has been detected.
Data is being exchanged through the WAN port at 100Mbps.
If this LED is dark
If amber
If green
No WLAN is enabled.
One of the WLANs is enabled, but no wireless client has associated.
At least one wireless client has associated.
If this LED is dark
If red
If blinking red/green alternately
If flashing green
If steady green
There is no network activity; no station detected at the WLAN port
There is a hardware problem affecting the WLAN port.
A signal is being detected at the WLAN port, but at the lowest level.
A moderate signal is being detected at the WLAN port.
A strong signal is being detected at the WLAN port.
FIGURE 2-2: Rear view
[1] Power Adapter plug
Connect the power adapter to
this socket. (Input 12V 1.0A DC or
5V 2.0A DC)
[2] LAN ports
Four RJ-45 ports, supporting 10/100
Mbps connections
[3] WAN Network port
One RJ-45 port, dedicated to ISP/
broadband source connection
[4] “OTA” (Over the air) button
Not active in this model at this time
[5] Reset button
[-IF NEEDED-] Use to reset AP to
“factory default” state
1
2
3
4
5
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 66 67

Comments to this Manuals

No comments