Ruckus Wireless ZoneFlex 7363 User Manual download pdf (Page 26)

VIEW Certified Configuration Guide: Ruckus Wireless

721-1004-000-E.docx

August 2014 26

WLAN Settings from the CLI

The minimum data rate for BSS is done through CLI by the following commands. This reduces

range from an AP slightly but improves throughput.

In addition, pmk caching must be disabled to enable the OKC algorithm expected for fast

roaming.

Finally, conversion of multicast and broadcast to unicast for AP’s that have less than 6 clients

should be disabled for the best handset interoperability.

ruckus> enable

ruckus# config

ruckus(config)# wlan <wlan name>

(The WLAN service <wlan name> has been loaded. To save the WLAN service,

type 'end' or 'exit'.)

ruckus(config-wlan)# bss-minrate 5.5

ruckus(config-wlan)# no pmk-cache-for-reconnect

ruckus(config-wlan)# no qos directed-multicast

ruckus(config-wlan)# qos directed-threshold 0

ruckus(config-wlan)# end

(message saying values were saved)

The DTIM must be set to 2 for good PTT (“walkie-talkie”) performance. These commands are

executed through a special debug interface which sends the setting out to all AP’s currently

attached.

AdminTip: Repeat when new APs added

These commands must be re-issued when a new AP is powered up and added to

the network.

Welcome to the Ruckus Wireless ZoneDirector 1100 Command Line Interface

ruckus> enable

ruckus# debug

ruckus(debug)# rksap_cli -A "set dtim-period wlan0 2”

ruckus(debug)# rksap_cli -A "set dtim-period wlan1 2”

…

ruckus(debug)# rksap_cli -A "set dtim-period wlan14 2”

ruckus(debug)# rksap_cli -A "set dtim-period wlan15 2”

ruckus(debug)# quit

1 2 ... 21 22 23 24 25 26 27 28 29 30

No comments

Ruckus Wireless ZoneFlex 7363 User Manual Page 26