Ruckus Wireless Metro Broadband Gateway User Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 64
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
USM-2825-RKS1-012907-01 Ruckus Wireless 2825 Wireless Multimedia Router 15
Placement Guidelines
Table 3 describes the rear ports and Adapters.
Placement Guidelines
The Ruckus MediaFlex Router will automatically adjust, within limits, to room conditions. You can achieve
better signal reception by following the below placement guidelines:
Establishing a good general location
Your 2825 should be placed:
Near the center of the room, if possible.
On a shelf or other elevated location where other wireless networking devices are within line-of-sight
access.
Away from other sources of electromagnetic interference (for example, microwave ovens, and cordless
phones).
Away from large metal surfaces, pictures or mirrors, metal bookcases, displays, racks, etc..
Away from large furniture or other physical obstructions, particularly metallic materials.
Using the Signal Quality LED to Fine-Tune the Placement
Wireless environments are sensitive to the physical arrangement of both electronic devices and furniture in
a room. You can observe the Signal Quality Indicator LED to determine the best location. The Signal Quality
indicator LED is described in Table 2— “LED Indicators and Meanings” on page 13.
Refer to the troubleshooting section on page 19 if video quality deteriorates after an installation.
If “Minimum Acceptable” or “Marginally Acceptable,” air quality is indicated, you can adjust the location
of the 2825 and other devices until a steady green LED indicates “good” signal quality.
Table 3—Rear Ports
Label Description
6 AC Power (Input 100-240V, 50/60HZ, 0.3A)
7 Five 10/100 Mbps Auto-sensing, autonegotiating RJ-45
network ports. The right-most port, labelled 'WAN', is to be
connected to the broadband gateway.
8
Reset button. Used only if you need to reset the 2825 to its
factory default settings. Insert the end of a paper clip or pin
into the hole and hold it in for at least 8 seconds.
9 Over the Air Auto Provisioning Button (not active for current
release).
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Comments to this Manuals

No comments